This page will show you the diagram on how to install the 4-piece set LED rock light kit.(50-070-White) There are some drilling, cutting and wiring required for the installation.

UniversalTail Lights

1. Place LED Rock Light on rear fender liner in front of the wheel, mark mounting location, and remove fender liner. NOTE: These are suggested mounting points only.

iJDMTOY.com automotive lighting was founded in 2004 and is now one of the largest car &truck LED lighting retailers in the United States. Our company is located in the suburb of Los Angeles, California, with the most complete LED lights and accessories for all cars and trucks including LED headlights, tail lamps, LED daytime running lamps, foglamps, off-road truck lightings, LED light bars, LED strip lights..... Read More>>

4. Install LED Rock Lights on fender liners using the Flat Mount rubber spacers, screws, nuts, 10mm wrench, and 6mm Allen Key. Once finished, reinstall fender liners.

6. Run wiring for front LED Rock Lights along the fender liner and up through the fender into the engine bay and wiring them to headlight or fog light +/- or run a switch.

Image

TrayTailLight panel

All manufacturer names, symbols, and descriptions used in our images and text are solely for identification purposes only. It is neither inferred nor implied that any item sold by iJDMTOY is a product authorized by or in any way connected with any manufacturers.

All manufacturer names, symbols, and descriptions used in our images and text are solely for identification purposes only. It is neither inferred nor implied that any item sold by iJDMTOY is a product authorized by or in any way connected with any manufacturers.

UteTail Lights

Tail Lamp, red/amber, suits BMW 3 Series. Fits Driver Side on 3 Series E36 Coupe, built from 5/1991 to 9/1996. This tail light is Q-Part Certified.

3. Drill mounting holes in each fender liner with a 1/4” drill bit. NOTICE: Use caution when drilling holes to ensure best possible fit of product.

5. Run wiring for rear LED Rock Lights along the pinch seam, securing with zip ties where necessary, and up through the fender into the engine bay. TIP: To help guide wiring through fender, drop a piece of string down the fender, tie to wiring, and pull up.