Under hoodLight

J. J. Keller protects people and the businesses they run. You can trust our expertise across a wide range of subjects relating to labor, transportation, environmental, and worker safety. Our deep knowledge of federal and state agencies is built on a strong foundation of more than 100 editors and consultants and 70+ years of regulatory compliance experience.

The SLR-2120 Emergency Area Light / Under Hood Work Light, is an all LED, hands-free floodlight. This rechargeable work light has an adjustable cradle with a pair of spring-loaded, foam-covered grippers that will extend 48”-70” to attach to a large variety of surfaces including the underside of most automobile hoods. The light bar can then be rotated 360 degrees to place the lighting exactly where it’s needed.

The SLR-2120 has two brightness modes: Full-power (1200 Lumens) and Half-power (650 Lumens). The dual on/off buttons, one located on each of the two handles, operate in tandem with each other. One press of either button turns the light on in Full-power Mode, a second press and you’re in Half-power Mode and then a third press turns the light off. The light bar can easily be removed from the cradle.

Under hood LEDLight Kit

I bought this light to use when working on my car or detaining the interior. No batteries to mess with, just plug the end of the light into the charger provided. One charger works with a wall outlet and the other works on a 12v car outlet. The light has 3 modes, bright, dimmer and strobe. There are built in hooks on each end to hang in or you can snap it into the other holder provided. That holder has padded claws on each end and the bar is under tension. This allows you to stretch the bar out and place each end on the edge of your hood and it will stay there. The padded claws prevent damage to the surface. Well worth the money!

The SLR-2120 Emergency Area Light / Under Hood Work Light, is an all LED, hands-free floodlight. This rechargeable work light has an adjustable cradle with a pair of spring-loaded, foam-covered grippers that will extend 48”-70” to attach to a large variety of surfaces including the underside of most automobile hoods. The light bar can then be rotated 360 degrees to place the lighting exactly where it’s needed.

CarLED Hoodlight installation

The hood claws detach from the light and my under hood light from harbor freight fits in it also so I can swap them out when one dies. The brightness of this one is better then the harbor freight one and this ones handles are much more durable as well.

Each of the handles can independently rotate up or down through more than 200 degrees range of motion. The flat surface at the end of each handle can serve as a stand for the light bar. Additionally, there are 3 flush-mounted magnets located at the end of each handle. This allows one or both ends of the light bar to be attached to virtually any flat metal surface. Each handle also has an integrated recessed hook that can swivel 360 degrees making it possible to hang the light bar up.

Under Hood LEDlight strip

I received this light as a present at Christmas 4 years ago and have used it extensively, but rarely in an automotive application. One of the first uses was at a Scout camp out to illuminate the entire mess tent. One of the first comments was "God that's a bright light". From that point forward I've always been reminded to bring the God light. It has lasted for more than a week, a few hours every night and early morning, I highly recommend this light for any application. Camp light, under hood light, I've even used it as a ceiling light when the power has failed.

The SLR-2120 has two brightness modes: Full-power (1200 Lumens) and Half-power (650 Lumens). The dual on/off buttons, one located on each of the two handles, operate in tandem with each other. One press. . . Show More >

The included AC & DC Power Supplies/Chargers can be used to power the SLR-2120 during use and/or as a way to recharge the unit when it’s not in use. Requiring only 6 hours to charge the SLR-2120 will run for 4.5 hours in Full-power Mode and 8.5 hours when operating in Half-power mode.

J. J. Keller protects people and the businesses they run. You can trust our expertise across a wide range of subjects relating to labor, transportation, environmental, and worker safety. Our deep knowledge of federal and state agencies is built on a strong foundation of more than 100 editors and consultants and 70+ years of regulatory compliance experience.